BashBench
An RC LiPo battery charging in a fire-resistant bag next to a balance charger

How to charge a LiPo battery for an RC car

The steps the battery makers actually publish, in order, with the 1C rule explained, a charge-time table, and the few mistakes that cause nearly all LiPo trouble.

How we pick · Updated · We earn a commission when you buy through our Amazon links.

Charge a LiPo with a balance charger set to LiPo and the pack's cell count, at 1C or less, inside a fire-resistant bag on a non-flammable surface, and stay with it until it's done. That's the whole method. The steps below come straight from the battery makers' own instructions, with the reason behind each one.

Where these steps come from

Every step paraphrases Horizon Hobby's Lithium Battery Safety document (54892), Traxxas's Battery Basics page or the Traxxas LiPo warning sheet, checked October 3, 2026. Where the two companies give different numbers, we say so. Your pack's own label and your charger's manual come first; this page doesn't replace them. Chargers and bags listed later are Amazon best sellers on the same date, with details taken from their listings. How we research.

What you need

  • A LiPo balance charger that handles your cell count. Horizon: "Always use a compatible charger with cell balancing, specifically designed for lithium batteries."
  • A lead that fits your pack's plug. Our connector chart identifies it.
  • A fire-resistant LiPo bag or fireproof container.
  • A non-flammable surface. Traxxas's example is concrete.
  • A cell checker, or a charger that shows individual cell voltages.
A charging station on a concrete floor with a charger and a LiPo bag
Concrete floor, bag, charger, nothing flammable nearby. Horizon adds: an open area, away from anything that burns.

Before the very first charge

Horizon lists three checks for a new pack. Look it over for "damaged or loose leads or connectors, damaged packaging, or other irregularities". Confirm the positive lead goes to the charger's positive terminal, with a voltmeter if you're unsure. And check that the pack's voltage is "consistent with the voltage listed on Batteries' label". A brand-new pack that reads far from its label shouldn't be charged; contact the seller.

Inspecting a LiPo pack for damage before charging
A split case, a pinched wire or a soft, puffy pack all mean stop. Traxxas: "If a battery becomes swollen, deformed, or appears damaged, DO NOT CHARGE."

How to charge, step by step

  1. Let the pack reach a safe temperature. Horizon says never charge a pack that's hot to the touch (above 100 °F) or below 40 °F. Straight after a run, let it cool first.
  2. Check the starting voltage. Horizon wants each cell at 3 V or more before charging; Traxxas sets its floor at 2.8 V per cell. Below that, the pack has been over-discharged. Don't charge it.
  3. Put the pack in the bag, on the non-flammable surface. Never charge inside the truck. Horizon says so in as many words: "Never charge Batteries inside of the model."
  4. Plug in the power lead, then the balance lead. The balance lead goes in the port that matches the cell count. On a multi-port charger, Horizon says to put the power lead and balance lead on the same channel.
  5. Set the charger. Choose LiPo and the cell count printed on the label, pick balance mode, and set a charge current of 1C or less (see below). Traxxas iD chargers do this automatically for Traxxas iD packs; for other packs, set it by hand. If your Traxxas charger is blinking at you, our Traxxas charger guide decodes the lights.
  6. Start the charge and stay with it. Traxxas: "NEVER: leave a battery unattended while charging, regardless of type." Horizon adds never overnight.
  7. Watch for heat or swelling. Traxxas says to disconnect "any time a battery gets hot to the touch during the charging process (temperature greater than 110°F / 43°C)". Horizon: if a pack balloons or swells, stop at once and disconnect the charger from its power source.
  8. Unplug when the charger says it's done. Never trickle charge a LiPo, and never let a cell go above 4.2 V. If the pack won't be used within a week, charge it to storage level instead of full, then follow our LiPo storage and bag guide.
Plugging a LiPo balance lead into a charger's balance port
The balance lead lets the charger see every cell. A 2S pack's plug has three pins, a 3S pack's has four.

The 1C rule, and when it bends

1C means a charge current equal to the pack's capacity: 5 A for a 5000 mAh pack, 2.2 A for a 2200 mAh pack. Horizon's document says the charger "should never be set to charge Batteries at a rate greater than 1C ... unless another C rate is specified in the manufacturer's product documentation or the rate is preset as part of a specific battery and charger combination."

Those exceptions are real. Spektrum's own 350 mAh SCX24 battery lists a 5C maximum charge rate. Traxxas's EZ-Peak Live sets 12 A automatically for its 2S iD packs from 6000 to 10000 mAh, which is above 1C at the small end, because the charger reads the pack and knows what it is. If your label says "2C charge", 2C is allowed. If it says nothing, use 1C. Traxxas's version of the rule is the same idea: "DO NOT exceed the maximum recommended charge rate."

How long it takes

At 1C, a pack charged from near-empty takes about an hour, plus a tail at the end while the charger slows down to top off and balance the cells. Below 1C, divide capacity by current for a rough figure. These are estimates; your charger's display is the real answer.

Pack1C currentTime at 1C (approx.)At 4 A (approx.)At 2 A (approx.)
2200 mAh2.2 Aabout 1 hour + tail1C is the limit, so 2.2 Aabout 1.1 hours + tail
3000 mAh3 Aabout 1 hour + tail1C is the limit, so 3 Aabout 1.5 hours + tail
5000 mAh5 Aabout 1 hour + tailabout 1.25 hours + tailabout 2.5 hours + tail
6700 mAh6.7 Aabout 1 hour + tailabout 1.7 hours + tailabout 3.4 hours + tail

Two things change the numbers. A pack at storage charge needs roughly half the time, because it's half full. And small chargers can't always reach 1C on big packs: Traxxas's EZ-Peak Plus tops out at 4 A on 2S and 3S, so a 6700 mAh pack charges below 1C on it. For small packs the maker's figure is the best guide; Axial says the SCX24's 350 mAh pack takes "approximately 45-60 minutes" on its USB charger.

The runtime side of the same arithmetic is in how long an RC car battery lasts.

The mistakes that cause most LiPo trouble

Wrong cell count on the charger

Set a 3S pack to 2S and it undercharges; set a 2S pack to 3S and the charger aims for 12.6 V on a pack that should stop at 8.4 V. Traxxas: "DO NOT charge a 2S (7.4V nominal) battery to more than 8.4V." Balance mode catches some of this, because the charger sees the cells, but check the setting every time.

Charging a pack that's been run flat

A pack that ran past its cutoff, or sat for months, can be below the safe starting voltage. Horizon says a pack below its minimum "should NOT be charged". Check before you plug in, especially for packs that have been in a drawer; Horizon says to check any pack out of service for more than six months.

Adapters on iD packs

Traxxas's VX3 manual says to use only a Traxxas iD charger for Traxxas iD packs and not to use adapters, because an adapter "defeats iD system safety protocols". If you own a mix of brands, a charger lead that matches each pack is a better plan than an adapter chain.

Walking away

Every document we read says it. Charge where you are, not while you're out or asleep.

Chargers and bags worth buying

If you don't own a balance charger yet, our beginner LiPo charger guide compares the main options in depth. These are strong sellers on Amazon this month, with the details from each listing:

  • SkyRC B6Neo: 1S to 6S, 200 W from a DC supply or 80 W over USB-C PD, with a storage mode. You supply the power source.
  • HOTA D6 Pro: two channels with AC or DC input, 1S to 6S LiPo, 0.5 to 15 A. Good if you charge two packs at a time.
  • Traxxas EZ-Peak Plus 2970: 2S and 3S LiPo plus 5 to 8 cell NiMH, reads Traxxas iD packs automatically, one-button storage charge.
  • Traxxas EZ-Peak iD USB-C (2985): 40 W, 4 A maximum, for 2S or 3S LiPo. It needs a USB-C cable and power supply that aren't in the box.
  • Spektrum S2100 G2: two 100 W channels on AC, with IC3 plus IC5 outputs that charge and balance Spektrum Smart packs through the main plug.

For the bag, the Zeee LiPo bag two-pack gives you a large and a small bag, and the Tenergy charging bag two-pack (5.5 × 3.5 × 2 in each) suits small packs only. A Tenergy 5-in-1 cell meter covers the voltage check in step 2.

After the charge

Let the pack cool before you run it, unplug it from the truck when you're done driving, and storage-charge anything you won't use within a week. The LiPo voltage chart has storage and cutoff voltages for 1S to 8S on one printable page, and LiPo vs NiMH covers how charging differs if you also run NiMH packs. Boat packs follow the same rules; our RC boat guide lists which boats take which batteries. Horizon's sheet carries an age line worth repeating for gift trucks: "Not for children under 14 years." The adult does the charging.

Steps paraphrased from Horizon Hobby document 54892, Traxxas Battery Basics and the Traxxas LiPo warning sheet; charger details from Amazon listings, checked October 3, 2026. How we research · Affiliate disclosure

Questions people ask

How long does it take to charge a LiPo battery?
At a 1C rate, about an hour from near-empty, plus some extra time at the end while the charger tops up and balances the cells. A pack at storage charge takes roughly half that. If your charger can't reach 1C, divide the pack's Ah by the charge current for a rough time: a 5000 mAh pack at 4 A takes about an hour and a quarter.
What is 1C when charging a LiPo?
One times the pack's capacity, in amps. For a 5000 mAh pack, 1C is 5 A; for a 2200 mAh pack it's 2.2 A. Horizon Hobby's safety document says never to charge above 1C unless the battery's documentation allows a higher rate or the rate is preset for a specific battery and charger combination.
Can I charge a LiPo with a NiMH charger?
No. Horizon says to always use a compatible charger with cell balancing, specifically designed for lithium batteries, and Traxxas says never to trickle charge a LiPo. A NiMH-only charger can't balance cells or stop at 4.2 V per cell.
Do I need to balance charge every time?
Use the balance mode every time if your charger has one. Traxxas iD chargers default to balance charging for LiPo, and Horizon's safety sheet says to plug the balance lead into the correct port before charging. Balancing keeps every cell at the same voltage, which a plain charge can't do.
Can I leave a LiPo charging overnight?
No. Horizon says never leave batteries charging unattended or overnight, and Traxxas says never leave a battery unattended while charging, regardless of type. Its app's remote monitoring is 'not a substitute for being present'.
How do I charge a new LiPo battery the first time?
Inspect it for damage, check that its voltage matches the label, and confirm polarity before you plug it in, as Horizon's sheet describes for the first charge. Then charge normally at 1C or less. Traxxas adds that new packs can take five or more cycles to reach full performance, so go easy on them at first.