BashBench
A 1/10 scale RC truck splashing through a shallow muddy puddle

Is my RC car waterproof? What each maker actually promises

Product pages say waterproof. The manuals say water-resistant electronics, and they mean it. One table for the trucks people own, plus the drying routine each manual asks for.

How we pick · Updated · We earn a commission when you buy through our Amazon links.

Short answer: the electronics in most hobby-grade trucks are protected against water, and the truck around them is not. Traxxas's product pages say "waterproof", but its own manuals say the model "should not be treated as though it is submersible or totally, 100% waterproof" and that water resistance "applies only to the installed electronic components". Arrma and Axial, both Horizon Hobby brands, put it as "water-resistant vehicle with waterproof electronics". Motors and bearings are a different story, and so are the batteries and transmitters. The table below gives each maker's exact wording for the trucks people actually own.

The master table

We read the current manual and product page for each model. "Product page" is the marketing wording; "manual" is what the maker says in the owner's manual, which is the one to plan around.

ModelProduct page saysManual saysWhat's covered
Traxxas Slash (2WD and 4X4, all current versions)"waterproof" or "waterproof electronics"Water-resistant; not submersible or "totally, 100% waterproof"Receiver, servos, ESC only
Traxxas Stampede (2WD and 4X4)"waterproof", "Fully Waterproof"Same Traxxas wording as the SlashReceiver, servos, ESC only
Traxxas Maxx and X-Maxx"Fully Waterproof"Same Traxxas wordingReceiver, servos, ESC only
Traxxas TRX-4M"fully-waterproof electronics""water resistant", not "totally 100% waterproof"ECM-2.5 module and steering servo
Axial SCX24 (most bodies)"water-resistant electronics""Water-resistant vehicle with waterproof electronics"Electronics waterproof; mechanical parts water-resistant
Axial SCX24 Power Wagon, 1967-72 C10 (AXI-3408)Spec field variesNo water section in the manualNot stated: treat as not water-rated
Axial SCX10 IIIWaterproof ESC and servo named"Water-resistant vehicle with waterproof electronics"ESC, servo, receiver (in a sealed box on the Base Camp)
Axial SCX30No water wordingNo water wordingNot stated: keep it dry
Redcat Ascent-18, Brushless, Scout II, APEXServo listed as "Waterproof Servo"No water sectionServo only; nothing stated for ESC or truck
Arrma Granite, Senton, Kraton 6S, Fury and the 223S GROMs"Waterproof" ESC and servo named; Kraton V6: "The electronics are waterproof""Water-resistant vehicle with waterproof electronics", same Horizon text as AxialESC, servo and receiver; mechanical parts water-resistant
Arrma brushed GROMs (Granite, Typhon)"Waterproof" ESC and servo namedNo manual on Horizon's site, only exploded viewsElectronics per the product page; nothing stated for the rest

Two oddities are worth knowing. Axial's own product pages contradict each other: the "Water-Resistant" spec field reads "Yes" on some SCX24 bodies and "No" on others that share the same electronics. And Traxxas's Stampede page says "Traxxas knows the difference between water resistant and waterproof", then the manual for that truck uses "water-resistant". Go by the manual. If you are shopping for one, see the best waterproof RC cars.

Which version do I have?

The wording differs by model and sometimes by generation, so find your exact model number first. Traxxas prints it on the manual cover and the box ("MODEL 68386-4" and so on). Axial's model numbers start with AXI and appear on the manual cover; for the SCX10 III, our SCX10 III review lists every version by part number. Within the SCX24 family, the transmitter tells you the electronics generation: an Axial AX-4 radio (Deadbolt, original C10, Betty), a Horizon HRZ radio (2019 JLU and the first Gladiator and Bronco) or a Spektrum SLT2 radio (current bodies). All three generations carry the same "water-resistant vehicle with waterproof electronics" section, except the two manuals noted in the table.

What "waterproof electronics" doesn't cover

  • The motor. Traxxas: "Even casual water contact can reduce the life of your motor." If it gets soaked, Traxxas and Axial both say to run it on very light throttle until the water clears; full throttle on a wet motor can kill it quickly.
  • Bearings and gearboxes. They aren't sealed, which is why every manual's drying routine is mostly about oil and grease.
  • The transmitter. Traxxas: "The Traxxas TQi transmitter is not water resistant." Axial: "Most transmitters are not water-resistant." Don't drive in the rain with it unprotected.
  • Batteries. Both makers: not all batteries can be used in wet conditions; ask the battery maker. Axial adds that caution is needed with LiPo in the wet.
  • Salt water. Traxxas says no salt, brackish or "other contaminated water". Axial says the same about salt water.
A small RC crawler crossing a shallow creek
A shallow crossing is what "water-resistant" is built for. Deep enough to submerge the motor is not: Traxxas says to avoid it on the TRX-4M.

Before you drive into water

Traxxas's manuals ask for three preparations. Drill or cut two small holes (3 mm, about 1/8 inch) in each tire near the centerline, 180 degrees apart, so water can escape. Check the receiver box seal. And gear down for mud or snow: on the Slash 4X4 VXL Traxxas says as low as a 9T pinion with the 54T spur, and on the X-Maxx as low as 11T. Traxxas also warns not to judge gearing by motor temperature in wet conditions, because the water keeps the motor can cool while the motor itself works harder.

Axial gives the same gearing advice in general terms: a smaller pinion or larger spur "will increase torque (and motor life)" in wet conditions. Our pinion and spur explainer shows how to swap one.

After the run: the drying routine

Traxxas and Axial publish nearly the same list. Here it is merged, with the differences called out:

  1. Spin the water out of the tires. Traxxas: a few high-speed passes on a dry, flat surface. Axial: body off, truck upside down, a few short full-throttle bursts.
  2. Remove the battery. Axial adds: dry the contacts and blow water out of the connector housing.
  3. Rinse off mud with low-pressure water such as a garden hose. Never a pressure washer, and don't aim water at bearings or the transmission.
  4. Blow it dry with compressed air (both say optional but recommended; Traxxas says wear safety glasses).
  5. Take the wheels off.
  6. Spray the bearings and drivetrain, plus the fasteners, with WD-40 or a similar water-displacing light oil. Axial: don't spray the motor.
  7. Let it stand and drip, ideally somewhere warm. Traxxas says trapped water and oil will drip for a few hours.
  8. Traxxas: remove the sealed receiver-box cover during storage so trapped humidity can dry. You don't need to unplug anything.
  9. After long wet runs, or before storing it for a week or more: re-oil the cleaned wheel bearings and re-grease the transmission and diffs. On brushed motors, clean the motor with motor cleaner and re-oil the bushings.
A muddy RC truck being rinsed with a garden hose
Low pressure only. A pressure washer drives grit and water straight into the bearings the manual is trying to protect.
Light oil being sprayed onto an RC truck's wheel bearing
Wheels off, then a water-displacing light oil on the bearings and drivetrain. It's the step most people skip, and the one that saves bearings.

The TRX-4M list is shorter because it uses self-lubricating bushings in many places, but Traxxas still says to spray the bushings and bearings along with other metal parts, and to clean the axle assemblies and transmission after extended wet use.

Making a truck better in the wet

Most wet-weather trouble is mechanical, so the useful upgrades are sealed bearings and steel drivetrain parts, not more electronics. The model upgrade guides cover what fits: TRX-4M upgrades, SCX24 upgrades and Arrma Granite upgrades. If you're starting from scratch, our first five upgrades for any basher puts the order in one place, and the Traxxas Slash 4X4 review covers how that truck holds up. If you'd rather drive on the water than through it, our RC boat picks are built for that.

Wording quoted from each maker's current owner's manuals and product pages (Traxxas, Arrma, Axial, Redcat), checked October 3, 2026. How we research · Affiliate disclosure

Questions people ask

Is the Traxxas Slash waterproof?
Its electronics are built to handle water, but the truck is not submersible. Traxxas product pages say 'waterproof electronics', while every current Slash manual says the model is water-resistant, 'should not be treated as though it is submersible or totally, 100% waterproof', and that this 'applies only to the installed electronic components'. The motor, bearings and transmitter need care.
Is the TRX-4M waterproof?
Traxxas's product pages call it 'fully waterproof', but the TRX-4M manual says it is water resistant, not 100% waterproof, with the protection applying only to the ECM-2.5 module and the steering servo. Traxxas also says to avoid water deep enough to submerge the Titan 180 motor.
Is the Axial SCX24 waterproof?
Axial's manuals use the heading 'Water-resistant vehicle with waterproof electronics': the ESC, servo and receiver are waterproof, most mechanical parts are only water-resistant, and the truck 'should NOT be treated like a submarine'. The Power Wagon and newest 1967-72 C10 manuals don't include that section, so check yours.
Can I drive my RC car in the rain?
The maker-rated waterproof electronics can take rain, but the transmitter usually can't: Traxxas and Axial both say their transmitters are not water-resistant. Some batteries aren't suitable for wet running either, so check with the battery maker, and dry the truck properly afterwards.
What do I do after running my RC car in water?
Follow your manual. The Traxxas and Axial routines are close: spin the water out of the tires, remove the battery, rinse with low-pressure water (never a pressure washer), blow it dry, pull the wheels, spray bearings and drivetrain with a water-displacing light oil, and let it drip dry. Clean and re-grease bearings and gearboxes more often.
Can RC cars go in salt water?
No. Traxxas manuals say not to let the model contact salt water, brackish water or other contaminated water, and Axial says the same about salt water. Salt corrodes metal parts and electronics.