A LiPo is a lithium-ion battery. The "polymer" refers to a gel electrolyte and a soft foil pouch instead of a liquid electrolyte in a metal can. Both charge to 4.2 V per cell. For RC cars the practical difference is current: hard-case LiPo packs are built and rated to deliver far more amps for their size, while cylindrical Li-ion cells hold more energy per pound and deliver less punch. That's why brushless trucks run LiPo and some toy-grade trucks ship with Li-ion.
What actually differs
Battery University's article on lithium-polymer puts it plainly: the modern Li-polymer cell adds a gelled electrolyte so it conducts at room temperature, uses laminated sheets in a foil enclosure that "reduces the weight by more than 20 percent over the classic hard shell," and has charge and discharge characteristics "identical to other Li-ion systems." Electronics Notes describes it the same way, as an enhancement of lithium-ion that uses the same anode and cathode materials.
So when RC people say "LiPo vs Li-ion," they're really comparing two packages:
| RC LiPo pack | Li-ion pack (cylindrical cells) | |
|---|---|---|
| Cell format | Flat pouch cells, often in a hard case | Round cells like 18650s in a steel can |
| Built for | High current for its size | More energy per gram, longer runs at moderate current |
| Typical RC use | Hobby-grade brushless cars, trucks, boats, drones | Toy-grade RC cars, transmitters, e-bikes, power tools |
| When damaged | Pouch can swell ("puff") | Steel can; check for dents and torn wraps |
| Charging | Balance charge, LiPo mode | Balance charge, Li-ion mode |
Voltages side by side
Per-cell numbers, from the sources named in each row. Multiply by the cell count for a pack.
| Per cell | LiPo (Traxxas, Horizon) | Li-ion (Molicel P28A datasheet) |
|---|---|---|
| Full charge | 4.20 V | 4.2 V |
| Nominal | 3.70 V | 3.6 V |
| Storage | 3.80 V (Horizon) | Not on the datasheet; follow the pack maker |
| Cutoff | 3.2 V under load (Traxxas LVD) or 3.0 V (Horizon) | 2.5 V discharge cutoff |
| Charge temperature | Pack between 40 °F and 100 °F (Horizon) | 0 °C to 60 °C (32-140 °F) |
Two things follow. A 2S Li-ion pack is often labeled 7.2 V where a 2S LiPo says 7.4 V, though plenty of Li-ion RC packs are labeled 7.4 V anyway. And because a Li-ion cell can run lower before its cutoff, a speed control set for LiPo will stop a Li-ion pack early. The PX4 autopilot documentation notes the same thing for drones: the standard low-voltage settings are too high to use a Li-ion pack's full capacity. Don't lower your cutoff below what the pack's maker publishes. Our LiPo voltage chart has every LiPo number by cell count.
Worked example: two real 2S packs
Here are two packs from Amazon, using only what their listings state. C ratings are the makers' claims, and hobby LiPo C ratings in particular are optimistic, so treat the amp figures as ceilings on paper.
| URGENEX 2S Li-ion 3000 mAh | Zeee 2S LiPo 5200 mAh 50C | |
|---|---|---|
| Labeled voltage | 7.4 V | 7.4 V |
| Capacity | 3000 mAh | 5200 mAh |
| Weight | 103 g | 250 g (hard case) |
| Size | 70 x 37 x 19 mm | 138 x 47 x 25 mm |
| Energy (V x Ah) | 22.2 Wh | 38.5 Wh |
| Energy per kg | about 216 Wh/kg | about 154 Wh/kg |
| Rated discharge | 15C = 45 A | 50C = 260 A |
The Li-ion pack stores more energy per gram. The LiPo, even heavy with its hard case, is rated for almost six times the current. That's the whole story for RC: a brushless truck's speed control is built around big current bursts (Arrma fits an 80 A speed control to its 3S Senton, for example), and a pack rated for 45 A would be the bottleneck and would run hot trying. A toy-grade truck with a brushed motor never asks for that much, so it gets the lighter, cheaper-to-make Li-ion pack.
The cell datasheet tells the same story. Molicel's P28A, a high-drain 18650, is rated at 2800 mAh and 35 A maximum (12.5C) at 46 g, with 219 Wh/kg. To match a LiPo's rated current you'd need several in parallel, and the pack gets bigger and heavier fast.

Which one to use
| Use | Pick | Why |
|---|---|---|
| Brushless basher or racer | LiPo | Needs high current; hard cases protect the cells |
| Toy-grade truck that came with Li-ion | Li-ion, same spec | Matches the stock motor and charger |
| Scale crawler on long, slow trail runs | LiPo, or Li-ion if the pack fits and the maker's rating covers your draw | Low current draw; capacity matters more than punch |
| Transmitter | Whatever the radio maker specifies | Radio chargers and cutoffs are set for one chemistry |
| Drone or plane built for endurance | Often Li-ion | PX4 docs: Li-ion has higher energy density, lower discharge |
If you're replacing a pack in a hobby-grade car, buy the chemistry and cell count the manual lists. Our best RC car battery guide covers LiPo and NiMH picks, and LiPo vs NiMH covers the older chemistry many RTRs still ship with.
Charging and safety
Both chemistries charge the same way, constant current and then constant voltage, and both must be balance charged as multi-cell packs. Molicel's datasheet charges the P28A to 4.2 V at a standard 2.8 A (1C). The Zeee LiPo listing says to charge at 0.5-1C on a LiPo balance charger and never unattended. Use a charger with a mode for each, and select the one on the pack's label. SkyRC's B6Neo lists LiPo, Li-Ion and LiHV modes for 1-6S; our beginner charger guide has other picks.
The safety rules battery makers publish apply to both. From Traxxas Battery Basics and Horizon Hobby's Lithium Battery Safety sheet:
- Never leave a charging battery unattended.
- Charge in a fire-retardant container on a non-flammable surface. A Tenergy LiPo bag (2,414 ratings) fits small 2S packs.
- Never charge LiPo on a NiMH charger or NiMH mode.
- Stop using any pack that's swollen, hot or damaged, and don't charge it.
- Store packs partly charged; for LiPo that's 3.8 V per cell (Horizon) or Storage mode on a Traxxas iD charger.
The step-by-step is in how to charge a LiPo battery, and long-term care is in our LiPo storage and bag guide.
LiHV and LiFePO4, briefly
LiHV is a LiPo built to charge above 4.20 V per cell. Spektrum labels its 2S LiHV packs "7.6V". Charge them only on a LiHV setting, and only to the voltage on the label. LiFePO4 (LiFe) is a different lithium chemistry with a lower cell voltage; it shows up in receiver packs and some transmitters, and it needs its own charger mode. None of these are interchangeable on a charger.
If you only remember one thing
Match the pack to the job, then match the charger mode to the pack. For a hobby-grade brushless truck that means a LiPo with a discharge rating that covers your speed control, charged on LiPo mode in a bag you can see.
Sources: Battery University "The Li-polymer battery: substance or hype"; Electronics Notes on lithium polymer; PX4 battery chemistry docs; Molicel INR-18650-P28A datasheet; Traxxas Battery Basics; Horizon Hobby Lithium Battery Safety 54892; Horizon's Arrma Senton 223S page; Amazon listings, checked October 13, 2026. How we research · Affiliate disclosure