BashBench
A large 1/5 scale electric monster truck jumping off a dirt mound

X-Maxx gearing chart and top speed, gear by gear

Traxxas publishes which pinion fits which spur on the X-Maxx, but not how fast each one goes. Here's that chart with a speed on every row, for 6S and 8S.

How we pick · Updated · We earn a commission when you buy through our Amazon links.

A stock X-Maxx 8S runs a 15T pinion on a 54T spur, and Traxxas rates it at 40+ mph on two 4S packs. The 50+ mph claim needs the 18/46 set that comes in the box, plus flat ground. Traxxas's chart lists 11T to 18T on the 54T spur, 14T to 19T on the 50T and only 18T on the 46T. Anything from 20T up doesn't fit. Below, every one of those combinations gets a speed.

Run your own numbers. The RC top speed calculator loads the X-Maxx 8S preset (1275 kV, 15/54, the 6.23 multiplier, 8.4-inch tires) so you can try any pinion, 6S or 8S, and your own efficiency factor.

Which X-Maxx do you have?

ModelStock gearingMultiplier in Traxxas's formulaTell it by
X-Maxx 8S Belted, 77096-4 (current)15/54, plus an 18/46 set in the box6.23Belted Sledgehammer tires, 2085X servo, "77096-4" on the box and manual cover
X-Maxx Ultimate, 77097-418/548.11Aluminum C-hubs and motor mounts, 2085RL servo
X-Maxx, 77086-4 (older)18/54 on Traxxas's chartNot confirmed (manual not online)Model number on the box or manual; Traxxas's pages don't say whether it was a 6S or 8S truck

The Traxxas Maxx (89086-4) is a different, smaller truck: one 4S pack, a 2400 kV motor, stock 23/50 and a 5.69 multiplier. Nothing on this page applies to it. The XRT is closer: it uses the same 1200XL motor with a different internal ratio (8.11 against the X-Maxx 8S's 6.23), covered in the XRT review. If your box or manual cover is gone, Traxxas's recall pages say to look on the chassis for the serial number, but they don't say where the model number is printed.

Where these numbers come from

The gear pairs and pin positions, along with the color categories, are copied from Traxxas's X-Series gearing page. The 6.23 multiplier, the 1275 kV Velineon 1200XL motor and the speed claims come from the X-Maxx product page and the 77096-4 owner's manual, all checked October 3, 2026. Traxxas lists the tires as "8.4 inches tall", and we used that as the diameter. Speeds are our calculator's theoretical figures plus an estimate at 0.85 efficiency, which is our assumption, not a Traxxas number. Nobody here has GPS-tested an X-Maxx. How we research.

The gearing chart with speeds

Theoretical speed uses nominal voltage (3.7 V per cell): 29.6 V for two 4S packs and 22.2 V for two 3S packs. The "category" column is Traxxas's own color key for the 77096-4.

Pinion / spurTraxxas categoryPinsFinal ratio8S theoretical8S at 0.856S theoretical
11 / 54RecommendedA F30.5830.8 mph26.2 mph23.1 mph
12 / 54RecommendedB F28.0433.6 mph28.6 mph25.2 mph
13 / 54RecommendedB G25.8836.4 mph31.0 mph27.3 mph
14 / 54RecommendedC G24.0339.2 mph33.4 mph29.4 mph
15 / 54StockC H22.4342.1 mph35.7 mph31.5 mph
16 / 54Higher speed, flat surfacesD H21.0344.9 mph38.1 mph33.6 mph
17 / 54Higher speed, flat surfacesD I19.7947.7 mph40.5 mph35.7 mph
18 / 54Higher speed, flat surfacesI18.6950.5 mph42.9 mph37.8 mph
14 / 50RecommendedA E22.2542.4 mph36.0 mph31.8 mph
15 / 50Higher speed, flat surfacesA F20.7745.4 mph38.6 mph34.1 mph
16 / 50Higher speed, flat surfacesB F19.4748.4 mph41.2 mph36.3 mph
17 / 50Higher speed, flat surfacesB G18.3251.5 mph43.7 mph38.6 mph
18 / 50Higher speed, flat surfacesC G17.3154.5 mph46.3 mph40.9 mph
19 / 50Higher speed, flat surfacesC H16.3957.5 mph48.9 mph43.1 mph
18 / 46Included high-speed setA E15.9259.2 mph50.4 mph44.4 mph

20T to 23T pinions are marked "does not fit / do not use" on every spur. The 50T row and the 46T row are on the same chart; the spur gears are sold separately (54T is part 6444, 50T is 6443, 46T is 6442 in the parts list).

X-Maxx 8S theoretical top speed by gear pair Bars for each gear pair on the 54T, 50T and 46T spurs. Speeds rise from 30.8 mph at 11/54 to 59.2 mph at 18/46. The stock 15/54 bar sits at 42.1 mph, next to Traxxas's 40+ mph claim, and the 18/46 bar at 59.2 mph next to the 50+ mph claim. 8S, nominal voltage, theoretical mph 11/5430.8 13/5436.4 15/5442.1 stock 17/5447.7 18/5450.5 14/5042.4 16/5048.4 18/5054.5 19/5057.5 18/4659.2 in box 40 mph50 mph recommended higher speed, flat only stock / included
Theoretical speeds for a selection of Traxxas's listed pairs on 8S. The dashed lines are Traxxas's two claims: 40+ mph stock and 50+ mph with the included set.

How the calculator lines up with Traxxas's claims

Closely, which is reassuring for both. Traxxas's manual says "When operating the X-Maxx with 4s LiPo batteries and stock gearing, the top speed is 40+mph". The calculator gives 42.1 mph theoretical for that setup. The product page claims "50+ mph with Two 4s LiPo Batteries and Included Optional Spur Gear"; 18/46 works out to 59.2 mph theoretical and 50.4 mph at our 0.85 factor.

A fully charged pair of 4S packs sits at 33.6 V, not 29.6 V, so the first pass on fresh packs can run above these numbers: 47.7 mph theoretical stock and 67.2 mph on 18/46. The speed drops as the packs settle toward nominal.

The X-Maxx Ultimate's 18/54 with its 8.11 multiplier is 24.33:1, which works out to 38.8 mph theoretical on 8S. Traxxas's Ultimate manual also says "40+mph" for 4S packs and stock gearing. Its speed claim, 50+ mph, needs optional gearing that isn't in the box.

A large RC monster truck running at speed on pavement
Traxxas's "higher speed" combinations are labeled for flat surfaces only. A speed run is a different job from a day at the skate park.

What taller gearing costs you

Every step up the table puts more load on the motor and speed control for the same throttle. On a 19-pound truck that load shows up as heat, and Traxxas says the higher-speed pairs are for "flat surface driving only" for that reason. Jumps and constant launches from a stop are where tall gearing cooks a motor.

  • Stay in the recommended rows (11T to 14T on the 54T spur, 14T on the 50T) for bashing and anything with jumps.
  • Use lower gearing in mud, deep puddles or snow. Traxxas's manual says "as low as 11T or spur gear as large as 54T" for those conditions.
  • Don't judge gearing by motor temperature after running in water. The manual says so directly, because water cools the can and hides the load.
  • Check the motor and speed control after the first few minutes on any new combination. We don't print a temperature limit because Traxxas doesn't publish one for the 1200XL.

Wear is the other cost. Traxxas's gearing page asks owners to use the recommended placements "to prevent undue wear and tear". Its X-Maxx pinions are sold "for use only with steel spur gears", and all three stock and optional spurs in the parts list are steel. Don't pair a steel pinion with a plastic aftermarket spur on this truck.

Changing gears on an X-Maxx

The X-Maxx doesn't use the slide-the-motor-and-feel method most trucks need. Its motor mount has numbered pin positions, and the manual says "A pin system helps set the motor in the proper place according to the pinion and spur gear that are selected." The letters in our table (A to I) are those positions, copied from Traxxas's chart. Set the pins to the letters for your pair and the mesh is set for you.

A pinion and steel spur gear on a large RC truck motor mount
Match the two letters on the chart to the pin holes in the mount. Traxxas says its chart covers both the stock plastic and the aluminum (part 7760) motor mounts.

Traxxas's pinions for this truck are 1.0 metric pitch (Mod 1) with a 5 mm bore: 6484X (11T) through 6491X (18T). If you buy aftermarket, match both numbers. Our explainer on pinion and spur gears covers pitch and bore, and how to set mesh on other trucks.

Useful parts for the swap, with the caveats from Traxxas's chart:

6S or 8S

The VXL-8s speed control is rated for "4S, 6S, or 8S LiPo battery power" with a 33.6 V maximum. Traxxas's minimum for the X-Maxx is two 5000 mAh 3S packs; its recommendation is two 6700 mAh 4S packs. Every speed claim it makes assumes 4S packs.

On 6S the whole table drops by a quarter: the stock setup is 31.5 mph theoretical and the 18/46 set 44.4 mph. If you already own two 3S packs from a 1/10 truck, 6S is a fine way to start. If speed is the point, gearing up on 6S is a poor substitute for two more cells. Our X-Maxx battery guide covers which packs fit the 197 × 51.5 mm tray and how to charge two at once.

Steel pinion and spur gears laid out on a workbench
Three spurs (46T, 50T, 54T) and pinions from 11T to 19T cover every pair on Traxxas's chart.

What we'd run

For bashing, leave it on 15/54 or drop to 13T or 14T if you run in grass or sand; the 54T spur's recommended range is where the motor is happiest. For a speed pass on a smooth lot, fit the 18/46 set that came in the box, use two fully charged 4S packs and check the temperatures after the run. That's the setup Traxxas's 50+ mph claim is built on, and nothing past it is on the chart. If the X-Maxx is still a shortlist question, our Kraton 6S vs X-Maxx comparison covers the other big basher. For cars built purely for speed, see our fastest RC car list.

Gearing chart and claims from traxxas.com and the 77096-4 and 77097-4 manuals, checked October 3, 2026. Speeds calculated by BashBench; the 0.85 factor is our assumption. How we research · Affiliate disclosure

Questions people ask

What is the stock gearing on an X-Maxx?
On the current X-Maxx 8S Belted (77096-4), Traxxas's gearing chart marks 15T pinion and 54T spur as stock, with an 18/46 high-speed set included in the box. The X-Maxx Ultimate (77097-4) ships with 18/54, and the older 77086-4 chart also lists 18/54 as stock.
How fast is an X-Maxx out of the box?
Traxxas's manual says 40+ mph with 4S packs and stock gearing (two 4S packs, so 8S). Its product page claims 50+ mph with two 4S packs and the included optional spur gear. The calculator puts the stock 8S setup at 42.1 mph theoretical, so the 40+ figure is believable.
What is the X-Maxx gear ratio?
Traxxas's manual gives the formula as spur teeth × 6.23 ÷ pinion teeth on the X-Maxx 8S. Stock 15/54 works out to 22.43:1. The X-Maxx Ultimate uses 8.11 in the same formula, so its stock 18/54 is 24.33:1.
What is the biggest pinion for the X-Maxx?
On Traxxas's chart for the 77096-4, 18T is the largest pinion on the 54T spur, 19T the largest on the 50T spur, and the 46T spur takes only the included 18T. Traxxas marks 20T to 23T as not fitting or not for use on any spur.
Is 6S or 8S better on an X-Maxx?
8S, if you want the speed Traxxas advertises. The VXL-8s speed control runs on 4S, 6S or 8S, and Traxxas's minimum is two 5000 mAh 3S packs (6S), but every speed claim assumes two 4S packs. On 6S the stock gearing works out to about 31.5 mph theoretical against 42.1 mph on 8S.
Can I gear my X-Maxx for speed and still bash it?
Traxxas marks the taller combinations as 'higher speed gearing and flat surface driving only'. Jumps, grass and repeated launches load the motor far more than a straight pass, so drop back to a recommended combination for normal bashing and check the motor temperature after a few minutes.